ptc heating element for hot melt glue gun

Ptc Heating Element for hot melt glue gun features:

1. Protective Nozzle Cover

2. Glue Display

3. Ergonomic Handle

4. Trigger Flow Control

5. Light weight

6. Bonds instantly

7. High quality

Hot glue gun designed for many applications. Fastening various materials such as fabric,wood, tiles, rubber, ceramics and flooring etc. Ideal for household repair,DIY&craft projects.

Ptc heating element for hot melt glue gun general Safety Information:

1. Check if the plug cord was in good condition, and if there is stand before plug into the electrical outlet ; Check if the used glue gun has glue flow through back of the tunnel;

2. Wait 5-10 minutes to allow glue to soften, stand up the glue gun on the table when not in use;

3. Touch nozzle to any clean, dry surface you wish to bond, to avoid any impurity stop the nozzle;

4. If the glue could not flow from the nozzle when the glue gun start to work, check if the glue gun are heating;

If glue gun can not be heated, there are following reasons:
1 Plug cord into electrical outlet not properly;
2 Glue gun has been destroyed owing to inner cord short circuit;

If glue gun can be heated, there are following reasons: Nozzle has been stopped by any impurity, ask careerman to manage it.

5. Do not use the glue gun under moist climate, humidity will affect insulation and cause electric shock;

6. Do not touch the nozzle or melted glue;

7. Do not remove out the melted glue stick from the tunnel back side, it will damaged the glue gun as well as scalding person hands.

8. Do not to disassemble or assemble any glue gun accessories freely, it will cause glue gun do not work properly;

9. Keep out of reach of children and stocked it beyond any of Children palpable side;

10. Only used for melting glue stick, no other usage;

11. When in use, there are any glue flow back from tunnel, stop using immediately, wait for careerman clean the glue;

12. Close the power if the glue gun not in use after 15 minutes;

Ptc heating element for hot melt glue gun using methods:

1. Glue gun using voltage is 110-220V AC,50/60 Hz;

2. Tip gun forward on stand and place a piece of cardboard under the nozzle

3. Use 7-8 mm (mini trigger glue gun), 11-12(big trigger glue gun), insert glue sticks through
tunnel at back of gun

4. After power, wait for 5-10 minutes to allow glue to soften

After glue softens, squeeze trigger to feed glue through glue barrel. Excessive force will damage glue gun. Put down nozzle after work, disconnect the power plug.

Contact us if you need more details on Ptc Heating Element for Hot Melt Glue Gun. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Cordless Glue Gun、Glue Spray Gun. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : High Quality Hot Melt Glue Gun > Mini Glue Gun